Double Shower Curtain Rod Installation Instructions

For rods 84 and longer assemble with the connector piece.

Double shower curtain rod installation instructions.

Before installing installation curved double shower curtain rod pencil level tape measure screwdriver drill hammer hacksaw drill bit 1. Lay the rod sections on the floor. There should be no gap between the base of the wall plate and the end of the rod. In this video we walk you through the steps in which you need to take to install your kenney double curtain rod in your home.

Using the hardware that is incl. Once level have an assistant mark where the rod intersects the other wall. X pilot hole anchor. Verify that the rod sections are the proper length for your installation.

Install the first bracket by screwing it into place. Then install the rod and place a level across the length of the rod. If not trim with a hacksaw. Then move on to the next hole repeating the same process.

Continue threading until all 12 rings have been threaded through all 12 holes. Drill pilot holes for the wall anchors. 7 slide the 2nd wall plate into the rod as shown below see figure d. Gently tap the anchors into the pilot holes with a hammer.

The method may vary by manufacturer. Install your brackets using these marks for a level rod. Extend the adjustable curved shower rod as needed until it is the correct length then install the other end of the rod into the bracket on the opposite wall. Thread the shower curtain hooks rings through the curtain and liner.

How to install spring loaded shower curtain rods. Straight double shower curtain rod installation 5. Starting from the left side thread one ring through the holes of both the curtain and the liner. If there is a stud in your mounting location use wood screws to attach the wall brackets.

Attach the rod and brackets to the wall with the mounting hardware provided. Spring loaded or spring tension shower curtain rods are a quick solution to getting your shower splash under control or brushing up a less than. Place the wall brackets onto the ends of the shower rod and tighten the set screws secure. Rotate the wall plate until it fits flush with the end of the rod.

Once you find the proper height level the shower rod.